GEN 2 - Firmware
General
Please read the Gateway Introduction so you understand the interaction between the different computer boards in the Gateway. You should first read this before using the below documentation.
Hardware Installation Guide
The Renson Smart Living modules can be easily installed without too much technical knowledge by using our
Detailed information about Hardware, schematics, PCB and other can be found in below section
Is my heating system compatible with Renson Smart Living?
Software Installation Guide
The Renson Smart Living modules can be configured by using the Cloud software (graphical interface) or by using the CLI (text) interface for manual setup.
Graphical user interface (Cloud)
Following Graphical user interface manual is available:
For full system setup using the Cloud Interface, see
For detailed switch setup and how to assign more functions to 1 switch, see
CLI user interface (Cloud "Maintenance mode" or RS232)
The below setup guides will explain the full programming of the Master Controller by using the CLI interface. It is however possible to install and configure the full Renson Smart Living system through the graphical cloud interface without using the CLI. Following CLI guides are available for manual setup:
To see all available RS232 CLI instructions, please consult
To add/change/remove modules and enable Large Installation mode using CLI mode, see
For basic system setup (add modules, assign inputs to outputs, set timers etc) using the CLI interface, see
For thermostat setup using the CLI interface, see
For advanced thermostat setup, Heating and cooling including Daikin setup using the CLI interface, see
For advanced system setup using the CLI interface, see
Master Controller Documentation
The technical firmware documentation (API, CLI, communication protocol etc) can be found here:
To see all available RS232 CLI instructions, please consult
To understand the different Basic Actions available in the Master, please consult the
Action Types (List of Basic Actions)
To understand the different debug codes in CLI mode, please consult
To understand the Error Codes appearing in CLI mode, please consult the
To understand the Memory model used in the eeprom of the Master controller, please consult the
To see all available RS232 API instructions, please consult
To understand the RS485 communication protocol, please consult
Master RS485 Communication Protocol
To understand how to use the CAN modules, please consult
To see the changes in the Master firmware, please consult
To see the changes in the CAN Controller firmware, please consult
Gateway Controller Documentation
Description of the Gateway architecture can be found here
The API instruction houses all Gateway controller instructions as well as all all Master controller instructions. This API can be found here
Renson Smart Living Python SDK
The Gateway controller has a plug-in systems that can be found here
Information about installing the Gateway can be found here
Information about Gateway network requirements for using the OM cloud can be found here
Open Source
Renson Smart Living want to be a fully Opensource product and we're in the process of publishing the sources. More info at our Open Source page.